Our Club Members SAVE MONEY and Have a Peace of Mind

Service Contract / Maintenance Contract

Water Heater Replacements – $749 Free Estimates On Furnace/Boiler Replacements Rooftop Heating System Repair Maintenance Contracts Available

Our Discount Plan includes:

$79 per year in Friendly Credits with combined coverage and an annual Heating and Cooling Tune-Up for maximum efficiency 50% off diagnostic fees 15% off repairs

Master Heating Tune-Up and Safety Check Furnace:

  • Test carbon monoxide levels.
  • Clean and adjust burners and inspect heat exchanger.
  • Check thermostat operation.
  • Lubricate all motors, bearings, fans and circulator pumps where possible.
  • Clean pilot assembly.
  • Install standard one-inch filters.
  • Test and adjust operation of safety and operating controls
  • Inspect flue pipe and gas valve.
  • Check blower motor (and belt if applicable).
  • Test and tighten all wiring and connections.
  • Turn exposed dampers to heating position if marked
  • Inform customer of equipment condition & recommend necessary repairs.

Hot Water Boiler:

  • Test carbon monoxide levels.
  • Check thermostat operation.
  • Check electrical connections.
  • Lubricate pump bearings and motors.
  • Clean combustion chamber.
  • Check pilot assembly.
  • Check zone valves.
  • Check all safeties.
  • Check flue pipe and draft.
  • Check expansion tank.
  • Check aquastat/relay.
  • Check water regulator.


Steam Boiler:

  • Test carbon monoxide levels.
  • Check thermostat operation.
  • Check electrical connections.
  • Clean combustion chamber.
  • Check pilot assembly.
  • Check all safeties.
  • Check flue pipe and draft.
  • Check and drain low-water cutoff.
  • Check gauge glass.
  • Check and adjust water level.
  • Check auto feed (if applicable).

Master Cooling Tune-up and Safety Check:

  • Lubricate all moving parts, such as blower motor & condenser fan.
  • Check suction line temperature and pressure.
  • Evaluate condition of air filters. Clean or replace with standard 1” filters.
  • Test temperature drop between return and supply air.
  • Flush condensate drain to protect against overflow.
  • Clean the outdoor condenser coil.
  • Check blower motor (and belt if applicable).
  • Adjust blower speed.
  • Safety test on all controls for proper operation.
  • Meter voltage and amperage in all motors. Test for worn bearings.
  • Test operation and condition of compressor contacts.
  • Inspect, start and run capacitors and relays for bulges, rust and leaks.
  • Tighten and safety test all wires and connections.
  • Clean and adjust thermostat/mercury bulb.
  • Inform customer of equipment condition. Recommend necessary repairs